If there is a DL error code on LG washer usually does not start the washing: the process does not go further than filling the tank. The equipment simply stands there and humming quietly from the incoming electric current.
What is the DL error related to?
The DL error code is found only on top-loading models of washing machines. The reason for this code is problems with closing the lid. The lid of the washing machine does not lock, so the system does not start the selected program. This may be due to one of the factors:
- stuck item;
- a faulty lock;
- damaged control board;
- bad contact
What can you do yourself?
In order for the DL error to disappear, you need to take a few simple steps. In some cases, they help to save on the call of a specialist.
- Check the door of the washing machine. Clothes or other foreign matter are probably stuck.
- Perform a hardware reboot. Turn off the washer for 10 minutes, then turn it on again and select the desired program.
- Make sure the cover is closed properly. Lift the cover and slowly lower it. Then click on Start / Pause. If the door snaps into place, the DL error will disappear and the drum will begin to rotate.
- Inspect the elements of the lock. The latch may have stuck. To do this, the latch must be cleaned from dirt and released if it is stuck.
When is the master’s intervention required?
If the cover is closed and the display shows a DL error code, contact service. It is necessary to call a specialist in the event that the problem is related to a failed control board, wire breakage or a malfunction of the interlock device. However, sometimes you can do it yourself.
Contact recovery
To resume normal signal flow from the blocker to the control module, you need to check the wires. If a break is detected, twist the ends and isolate the junction. Also inspect the groove, which includes the plug with the wires. It is possible that she moved away from the vibration of the washing machine.
Replacing the door lock device
Inspect the door lock device. Perhaps it is because of him – the reason DL error code on LG washer. In this case, the only way out is to replace the door lock device, because this element is not repairable. Its cost is from $ 10 to $ 39.
Control Board Repair
The board fails for two reasons: from moisture or due to power surges. Therefore, any attempt to restart the technique leads to the appearance of the DL error code on the screen again. In most cases, the module is subject to restoration. To do this, re-solder the triac (relay) and the burned-out tracks. But in most cases, it is better to call a wizard when repairing this part, especially if you do not have experience in repairing electronics. If all else fails, change the control unit. Its price is from $ 150 and above.